If your plumbing goes haywire, it can really cause problems in your home. Stop plumbing problems before they start by applying the following tips.
You don’t want to end up with frozen pipes, so take preventive action, such as wrapping outside pipes with insulation, and keeping indoor temperatures above freezing at all times. The pipes will be able to freeze if the temperature surrounding the pipes drops below freezing. In the best situation, it can take hours for frozen pipes to thaw and water to run freely again. They could also burst costing you a lot of money and repairs.
If you want your garbage disposal to have the same lifespan as your total home, clean it regularly. You can prevent annoying odors and promote smooth operation by setting up a regular cleaning routine with lemon rinds, dish soap, and even cherry pits.
Schedule all the plumbing work at one time. You might be tempted to have a plumber come out for every little thing that happens, but kicking the can on some issues until you have a list means you can save a few bucks. It also saves you money because a lot of plumbers charge by the hour–they cannot charge for multiple hours every trip if they only make one trip out.
Pour equal parts baking soda followed by vinegar down your bathtub drain once a month. Plug the drain afterwards or cover it with a washcloth, as the two chemicals are going to react with each other. Pause a few minutes, and then follow the mixture with boiling water. This procedure will clear the hair and soap scum out of your pipes.
Be sure that the dryer’s lint trap is clean. This not only prevents fires, but saves money. See to it that you look at the lint trap and find out if it has tears or holes in it that could cause lint to go inside your pipes. This could lead to clogs or other problems in the future.
Frozen pipes can cause you to incur expensive plumbing repair bills. This problem is easily avoided. If you have any pipes outside, have them properly insulated. When cold weather sets in, turn off your outside faucets, disconnect all hoses and drain them. You can avoid future plumbing repairs by doing this, and therefore, saving you a lot of money.
Over time, sediment buildup may lead to problems with low water pressure. Often, this problem can be addressed by thoroughly cleaning out the aerator. Take out the aerator, pull it apart, and clean inside with a brush soaked in vinegar. Rinse the aerator with water, put it back together and then attach it back onto the faucet. This should raise the water pressure nicely because anything that was inside of the aerator will be removed.
Plumbing ca be a very hard issue to deal with, but if you do some work and exhibit patience, you can help them. Asking around and doing a bit of homework may get you some positive results. Keep the above tips handy to save time, money and effort.